Alpina Rootage Evo Casco, Oliva

Whether on the trail, freeriding or with the e-fully in the bike park. The ROOTAGE EVO is a good choice. The helmet construction, which is pulled over the ears, offers significantly more safety than a half-shell helmet, especially in the case of side impacts. In addition, the EPP used at the ears, a multi-density material that does not lose its protective effect even after repeated impacts, is used in the rear area of the helmet. The fixed shield directs the air into the large ventilation channels of the ROOTAGE EVO and thus cools the head. The ROOTAGE EVO is the first bike jet helmet with a size adjustment system and also allows you to wear a neck brace. Protection, comfort and flow are guaranteed with the ROOTAGE EVO.

Run System Ergo Pro

With the Run System, the size of the helmet can be individually adjusted on all Alpina helmets via a smooth-running dial. A striking feature of the high-quality Run System Ergo Pro are the two large wing-shaped headrests. They are made of a two-component mix consisting of plastic and rubber. This guarantees maximum comfort. Since 2014, the Run System Ergo Pro has been available in colours to match the helmet.

A helmet can only provide the best possible protection if it remains in the optimum position in the event of an impact. The adjustment and fixation of the two straps under the ear plays a decisive role. The Y-Clip system guarantees millimetre-precise adjustment - in a matter of seconds.

Proven hundreds of thousands of times and used on all Alpina helmets: the belt buckle with the red push button and multi-stage automatic snap-in mechanism. Ergomatic can be operated with one hand - you can loosen the strap uphill, tighten it downhill - and in the event of a fall it is not possible for the locking mechanism to open automatically.

Edge Protect is an additional polycarbonate sheet that refines Inmold helmets. It covers edges on the underside of the helmet. This protects the Hi-EPS and increases the longevity of the helmet. At the same time, the neck and shoulder area of the rider is protected against injuries from the helmet in the event of an impact and contact with the lower edge of the helmet.

One factor that strongly influences the wearing comfort is the ventilation of the helmet. The strategically sensible arrangement of the ventilation openings is decisive for optimum ventilation of the interior. The air is directed into the interior, directed along the head and can then flow out again at the rear. The head is therefore always pleasantly air-conditioned.

The inner shell of all Alpina helmets is made of Hi-EPS (High Expanded Polystyrene). The material has microscopically small air chambers which absorb the forces acting on the helmet in the event of an impact. Hi-EPS provides optimum protection and at the same time enables extra-thin wall thicknesses and narrow helmet shapes.

In the Inmold production process, the polycarbonate helmet shell is thermally bonded to the Hi-EPS inner shell of the helmet body under great heat and pressure. This creates a large-area and inseparable connection between the upper and lower shell. Advantage: The helmet is very light and at the same time extremely stable.

All Alpina helmets manufactured using the Inmold process receive a robust Ceramic Shell. A polycarbonate plate is stretched under high heat onto the shape of the later helmet and pressed under high pressure onto the Hi-EPS body and thermally connected to it. The Ceramic Shell is characterized by several qualities: It is break- and scratch-resistant, UV-stable and antistatic.

Custom Fit is an adjustment system at the back of the head that allows you to adjust the height of the Run System in several stages. This allows the optimum fit of the helmet to be adjusted for a wide range of head shapes. Pressure points are a thing of the past, the fit of the helmet is perfect and safety is increased.